cubby shelves woodworking plans
- step 1
- step 2
- step 3
- step 4
Dimensions:
63 1/2″ x 30 1/4″ x 12 3/4″
Shopping List:
4 – 8′ 1×12 Boards (Cut all of the long cuts first, short cuts from the scraps)
8 – 1×2 Boards, 8′ Length
1 1/4 inch screws
2 inch screws
1 1/4 inch finish nails
2 inch finish nails
1 1/4 inch pocket hole screws
2 1/2 inch pocket hole screws
wood glue
wood filler
120 grit sandpaper
primer
wood conditioner
paint
paint brush
Tools:
measuring tape
square
pencil
hammer
safety glasses
hearing protection
Kreg Jig™
drill
circular saw
nailer
sander
Cut List:
Cut List for the Box
2 – 1×12 @ 30 1/4″ (Sides
1 – 1×12 2 63 1/2″ (Top)
2 – 1×12 @ 62″ (Shelves)
6 – 1×12 @ 14″ (Vertical Dividers)
Cut List for the Trim (I recommend cutting your trim to the project specific measurements and using these numbers as a guide)
4 – 1×2 @ 63 1/2″ (Top and Bottom Trim)
10 – 1×2 @ 28″ (Vertical Trim)
8 – 1×2 @ 14″ (Shelf Trim)
3 – 1×2@ 11 1/2″ (Caster Wheel Supports)
General Instructions
Work on a clean level surface. Take a square after each step. Use glue and keep outside edges flush as necessary. Use proper safety equipment and precautions.
Step 1
Build the Box. Begin by fastening through the sides with 2″ nails and glue to the shelves. Use the measurements above to guide you. Then fasten the top in place.
Step 2
Dividers. First fasten all the bottom dividers in place, fastening through the shelves into the ends of the dividers. Mark out the proper spacing. Then fasten through the top into the top dividers. To fasten the bottom edge of the top divider, nail at an angle through the bottom corner of the divider into the shelf. Use 2″ nails and glue.
Step 3
Trim. Using 2″ nails and glue, fasten the trim in place, measuring to fit. You may wish to mark the top and bottom trim before fastening the vertical trim in place. The shelf trim is flush on the top with the shelves.
Step 4
Caster Supports. Using 1 1/4″ nails and glue, fasten the caster supports to the bottom of the piece. Then fasten your casters to these pieces.
Finishing:
Fill any nail holes with wood filler and sand and finish as desired.
cubby shelves woodworking plans,