Latest Items

flat wall book shelves woodworking plans

Added/Modified on November 16, 2016
VN:F [1.9.21_1169]
Rating: 0 (from 0 votes)
VN:F [1.9.21_1169]
Rating: 9.0/10 (2 votes cast)

Shopping List:

1 – 12′ 1×6 Board (cut sides out of this board)
1 – 8′ 1×6 Board (cut shelves out of this board)
3 – 1×2 Boards
40″ of 3 1/4″ Base Moulding, between 1/2″ and 1″ thick
2″ Screws
1 1/4 inch pocket hole screws
wood glue
wood filler
120 grit sandpaper
primer
wood conditioner
paint
paint brush

Tools:

measuring tape
square
pencil
hammer
safety glasses
hearing protection
Kreg Jig™
drill
sander
level

Cut List:

2 – 1×6 @ 57″ (Sides, Top Cut out in step 1)
4 – 1×6 @ 22 1/2″ (Shelves)
11 – 1×2 @ 22 1/2″ (Back Supports and Front Rails)
3 1/4″ Base Moulding, mitered for footer

Step 1

Side Cutouts. Using the measurements above to guide you, cut out the sides at the top as shown above. Once one side is cutout to your satisfaction, use it as a pattern for the other side. This will keep the side the same. Use either a bandsaw or a jigsaw.

Step 2

Box. Build the box by using 2″ screws and fastening the shelves to the sides, as shown above. Measurements above are to the bottoms of the shelves.

Step 3

Back Supports. Fasten the back supports to the sides and the shelves. Make sure the bookrack is square before this step. Use 2″ screws and glue.

Step 4

Front Rails. Cut out 4 of the front rails (1×2 @ 22 1/2″) in a simple arch shape above as shown in red. Then, as you did the back supports, fasten the front rails in place. Make sure you bookrack is square before fastening the rails, as this step will set the bookrack.

Step 5

Footer. Using 3 1/4″ store bought base moulding, cut your footer with the outside corners mitered at 45 degrees. Preferred fastening method is to use 1 1/4″ brad nails, but you can also use a couple of screws and wood glue (or a good ole hammer and nails). Dimensions are not given because your moulding could be any thickness.

Step 6

Finishing. Fill any holes with wood filler and sand and finish as desired. Screw through the back supports into a stud in the wall to keep the bookrack in place. You could alternatively use a picture hanging kit to fasten the bookrack to the wall.

VN:F [1.9.21_1169]
Rating: 9.0/10 (2 votes cast)
VN:F [1.9.21_1169]
Rating: 0 (from 0 votes)
flat wall book shelves woodworking plans, 9.0 out of 10 based on 2 ratings

Comments

comments


Powered By SageFox. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.
SageFox Free PowerPoint - PowerPoint Slides - PowerPoint Images - Social Tags - Woodworking Plans - eLiquid eJuice | Health Remedies - DIY Ally